I could probably drive the bearing off the shaft but will no doubt do serious damage to the threads on the shaft. There are some severe marks on the outside of the bearing that looks like the PO put those bearings on with a punch or something like that. I looked at the threads on the end of the shaft with a magnifying glass and noticed that the threads are about half flattened. The bearing on the wheel end (opposite the pulley) slides about half way over the threads and will not come any further. The bearing on the pulley end came off the shaft with no problem. NEW DAY NEW PROBLEMā¦.oK peopleā¦.I got the lower shaft and bearings out. I was taking pics with my cell as I went. They go a specific way so when they come out, put them back the same way. The clip things are a type of bearing spring. It is a heavy shaft so it should not hurt it. Yes, I did gently tap it through with a wood block.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |