To help minimize dust during the demolition, remove the door towards the end of the process prior to extracting the main frame. Before you can remove the door and main frame, you must cut the caulking, remove the interior and exterior trim, and remove the 1×4 nailing boards around the exterior of the frame and any shims or nails sticking out of the trimmer studs. This requires removing the door as well as the existing exterior trim and old insulation. If not, you're going to need to consider a new door. If they match up closely, then you're good to go. Check the measurements of the old door against the measurements of the new door you're considering.The smallest number is again going to be your rough estimate. For door height you're going to need to measure the middle, and both sides of the door from the top of the door to the floor.The smallest number is the rough estimate for the width. The stud is basically the side of the door. To check the width you'll need to measure across the top middle and bottom from stud to stud of the old door.Home Improvement Specialist Expert Interview. X Research source X Expert Source Ryaan Tuttle You can avoid this unfortunate situation by taking measurements of the old door and applying those measurements to the new door. There's nothing worse than getting all primed to go with your new door only to discover that it is too big or too small.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |